CW TOUCH PADDLES
MODEL P3K (kit)
SMD parts are pre-installed
DUAL TOUCH PADDLE CIRCUIT CARD
Thousand already sold!
Just add your own creative conductive metal paddle.
No Moving Parts or Contacts to Wear Out No Adjusting Required No Falsing Superior Response
ONLY 1.25" W x 1" D x .4" H
Use your imagination to create your perfect paddle.
Create your own set of touch paddles using just about any conductive metal and wire
them to the model P3 circuit card. (up to 24" away)
Model P3K circuit card is so small (ONLY 1.25" W x 1" D x .4" H)
it can fit inside most homebrew equipment.
Operates on 6-14 DC volts. Positive Keying of 13.8 Volts or Less.
Paddle separation: > .25" (To prevent capacitive paddle interaction paddles should be separated by a minimum of .25".
However, this specification will vary with paddle size.)
This product is ideal for you to use your creativity and talent in developing your own unique paddles.
NOTE: The keyer output transistor circuit is designed to switch key input
of 13.8 Volts positive or less.
Do not attempt to use any CW Touch Keyer products with a vacuum tube transmitter
(either grid blocked or cathode keyed) without an appropriate output circuit.
Consider purchasing the “keyall” kit from Jackson Harbor Press for tube type keying.